Skip to Content
Hive Tree Services β€” Job Safety Analysis (JSA)
Hive Tree Services

Job Safety Analysis

Must be completed at the start of every job

Job details

Same staff list as "Select all staff onsite today" below. An admin edits both lists together in the form editor whenever staff change.

Type the address, or tap "Use current location" to fill it in and attach a map link automatically.

Fitness for work & wellbeing check-in NEW

Rested, and not affected by illness, medication, alcohol or drugs.

General check-in β€” no personal or work-related concerns affecting focus or safety today.

Support is available. This form isn't private β€” if something's on your mind, reach out instead of writing it here. Email hr@hivetrees.com.au β€” it goes privately and directly to your supervisor. Beyond Blue: 1300 22 4636 (24/7) Β· Lifeline: 13 11 14.

Wind, heat/UV, storm activity.

If No: do not commence. Monitor conditions and reassess before starting.

Task/s being performed today

You ticked "Other" β€” add the detail below.

Select all staff onsite today

From your Employees list.

Before starting work

Select high-risk activities being performed today. Ticking an item below will reveal its specific pre-start checks further down the form. NEW

SWMS reference numbers removed for now while your SWMS documents are being rewritten β€” this list is just the activity names until they're reattached.

Deadwood, decay/cavities, lean, co-dominant stems, prior damage, epicormic growth, root-plate issues.

If No: STOP. Do not commence work. Contact your supervisor to review or update the SWMS before proceeding. This also applies mid-job β€” if conditions change and no longer match the SWMS, stop work immediately and contact a supervisor before continuing.

Task-specific pre-start & competency checks NEW

Only the blocks for activities ticked above will show here.

Chainsaw

Fuel, chain tension, chain brake, guards checked. Refuelling done with engine off and cooled.

Chipper / mulcher

Guards and emergency stop checked. No loose clothing/jewellery near the infeed. Push-stick used for short material. Never left running unattended.

Stump grinder

Includes underground services checked (Dial Before You Dig) and safety barriers set.

Mini loader

EWP

Emergency lowering device tested. Operator holds the correct high-risk work licence. Safe working load not exceeded. Fall-arrest harness worn and connected.

Tree climbing

Rope, harness, karabiners, lanyards checked. Continuous attachment maintained while climbing. Two-point (tie-in) attachment while cutting. Tools secured with karabiner/lanyard.

Working near power lines

Energy Safe Victoria's No Go Zone extends up to 6.4m depending on voltage. If work is within it, a person with current line-clearance authorisation must be on site directing the work.

Aerial rescue NEW

Shown because climbing or EWP work is ticked above.

Site Conditions

Hierarchy of Controls NEW

Follows WorkSafe Victoria's hierarchy of control β€” work through each level in order, most to least effective, before relying on PPE. Steps 2 and 3 only appear once a high-risk activity is ticked above β€” a simple job with none ticked just needs Eliminate and PPE confirmed.

Environmental & site-specific checks NEW

Checked for wildlife (possums, nesting birds, bats) in hollows or dense canopy before removal/heavy pruning.

If fauna is present: do not proceed. Contact your supervisor β€” may need a fauna spotter/catcher or permit.

E.g. tree removal permit, council permission, road occupation permit.

Communication & emergency NEW

Chainsaw/chipper noise can prevent verbal instructions being heard β€” worth agreeing a backup method.

Relevant given fuel and chainsaw use.

Sign Off

Every person on site adds their name below and confirms they've read and understood this JSA and the SWMS(s) referenced above.